How to choose the right RCDs?

RCD selection is an important aspect of any installation, ensuring adequate protection against potentially fatal electric shocks. Paul Collins, Technical and Training Manager at Hager, tackles FAQs from contractors.

What type of RCD should I use?

RCD use has been in existence for a long time, and the revised 18th Edition regulations clarified their selection and specification to further enhance safety standards. Electrical contractors need to carefully consider the type of RCD required depending on the type of equipment which may be connected in the installation.

There are four types of RCD, with each reacting differently depending on the presence of DC components or different frequencies. In order for contractors to specify the correct product, the different types of RCD can be classified as:

– Type AC RCD – general purpose use. Type AC RCD can detect and respond to AC sinusoidal residual current only.

– Type A RCD – equipment incorporating electric components. Type A RCD can detect alternating sinusoidal residual current and residual pulsating direct current suddenly applied or smoothly increasing. It is important to remember that Type A is also suitable for Type AC applications.

– Type F RCD – equipment with frequency controlled speed drives. Type F RCD can detect and respond to high-frequency residual current, as well as pulsating DC residual current.

– Type B RCD – electric vehicle chargers, PV supplies. Type B RCD can detect and respond to all types of residual current including smooth DC residual current.

What does Hager recommend?

Due to the style of circuits, the nature of loads connected to these circuits and the frequent use of RCDs to protect a group of circuits, Hager believes that the majority of electrical circuits in residential and commercial applications will require a Type A RCD solution.

What type of equipment/load is best protected by a Type A RCD solution?

Single-phase with electronic components which would typically comprise items such as:

  • Single-phase inverters
  • Class 1 IT and multimedia equipment
  • Power supplies for Class 2 equipment
  • Appliances such as a washing machine that is not frequency controlled
  • Lighting controls such as a dimmer switch and home and building electronic systems
  • Induction hobs
  • Electric vehicle charging where any smooth DC fault current is less than 6mA.

– This article originally appeared in the November 2019 issue of ECN.

You May Also Like

Crestron opens new Design and Experience Centre in Leeds

Crestron opens new Design and Experience Centre in Leeds Crestron has announced the grand ...

Amber Solutions’ Energy Traffic Controller promises efficiency and stablilty

Amber Solutions has announced the latest innovative design to leverage its technology — a ...

Making Sense Of The Future Home Standard

Making Sense Of The Future Home Standard

With the recent introduction by Government of the Future Homes Standard Consultation, Elmhurst Energy ...